Esu ECoSBoost Manual de instrucciones descargar pdf (Pagina 8)

8.3.2. Wiring three-conductor tracks

Please pay attention to the right polarity, as otherwise some older

decoders (e.g. k83) will not work.

Wiring takes place as shown. If your new Motorola® locos work

but the old k83 accessory decoders and older Märklin® locos do

not it is most likely that polarity has been swapped.

Märklin® offers a suitable connecting track for the C-track system.

Part number 74046 is not suitable! For the K track system you

should use the connecting track No. 2290.

8.4. ECoSlink connection

Viathebuscablethatisincludedindelivery,theECoSBoostcan

be connected to one of the ECoSlink-Connect sockets of the com-

mand station. Please make sure that the cable is in the correct

position.

Wiring details

Figure 6

•Neverconnectanotherdigitalsystemoranaloguetransformer

to the same circuit as the ECoSBoostBoost. The ECoSBoost-

Boost may be damaged or destroyed!

•Dependingontherespectiveversion,theECoSBoostBoostsup-

plies up to 8A track current. Always consider if you actually

need such a high output current. In case of a short circuit your

locos may be damaged and there may be risk of ﬁre! Also refer

to chapter 10.2 regarding the current reduction.

•Please always ensure that the polarity of all track sections is

identical! Terminal “B” of the ﬁrst ECoSBoostBoost and ter-

minal „B“ of the following booster must be connected to the

same side of the track! Otherwise, this will lead to short-circuits

whenever a locomotive crosses the district boundaries between

the sections!

Remove all capacitors that may possibly haven been wired to the

track power supply cable in your layout. They would cause a strong

heat build-up of the booster and impair the power output. Almost

in every connecting track in an analogue starter kit (Roco®, Mär-

klin®) are, respectively were, capacitors installed.

8.3.1. Wiring two-conductor tracks

Wiring takes place as shown. Polarity is not an issue (for DCC or

Selectrix®).



Supply area 1

Supply area 2

Isolated tracks on both sides!





Figure 7

Supply area 1

Supply area 2

Isolate the middle conductor!





Figure 8

ECoSlink Connect, 7pin

Booster connection cable

6pin





Figure 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios

Esu ECoSBoost Manual de instrucciones Pagina 8

Comentarios a estos manuales