Esu ECoSBoost Manual de instrucciones

1Instruction manualSecond Edition, October 2011ECoSBoost Digital AmplifierESU P/N 04011-10679

1010.1. Change the name of the boosterThe default factory name of the booster can be changed at any time, so it is easier to distinguish the boosters.

1112. Stop” and “Go” buttonIf you have at least one or more ECoSBoost devices connected to your command station, the behaviour of the

12 Figure 14ECoS System overview15. ECoS System overview

1316. Technical data16.1. Technical data ECoSBoost 4A 50010HardwareH4 booster with 4.0 A continuous output power. Output is over-load and short-circ

14Notes

1517. Warranty Certificate24 Months warranty form date of purchase Dear customer,Congratulations on purchasing this ESU product. This quality product

16ESU P/N 04011-10679

2Content1. EG Declaration of Confirmity ...32. WEEE-Declaration ...33. Impor

3Declaration of Confirmity1. EG Declaration of ConfirmityWe, ESU electronic solutions ulm GmbH & Co. KG, Edisonallee 29, D-89231 Neu-Ulm, Germany,

4Introduction & Starting up Figure 15. Unpacking and starting upThe ECoSBoost is safely protected in a carton with a two-part blis-ter when delive

56. Features of the ECoSBoostThe ECoSBoost is available in two versions which, respectively, have a different maximum output.6.1. Power Amplifi

68. Power supply8.1. Power supplyThe ECoSBoost 4A gets its power via a 2.1mm DC-socket, the ECoSBoost 8A via a 4-pin Mini-DIN socket. Basic

78.2.2. 9A Power supply VIn:  100V–240VAC,50/60HzInput current: 3.6A max.VOut:  19VDC,stabilisiertOutput current: 9.5A max.Plug: 4-

88.3.2. Wiring three-conductor tracksPlease pay attention to the right polarity, as otherwise some older decoders (e.g. k83) will not work.Wiring take

9To avoid incorrect connection the amount of contact pins varies on both sides. Please only use the supplied cable that comes with the delivery.